Toyota Tacoma 2015-2018 Service Manual: 2gr-fks Fuel
- Fuel Injector(for Direct Injection)
- Fuel Injector(for Port Injection)
- Fuel Main Valve
- Fuel Pressure Sensor
- Fuel Pressure Sensor(for High Pressure)
- Fuel Pump
- Fuel Pump Ecu
- Fuel Pump(for High Pressure)
- Fuel Sender Gauge Assembly
- Fuel System
- Fuel Tank
Installation
INSTALLATION
PROCEDURE
1. REMOVE MONOLITHIC CONVERTER PROTECTOR
(a) Install the upper monolithic converter protector and lower monolithic converter
protector with the 2 bolts and 2 nuts.
Torque: ...
Other materials:
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Check the DTCs.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Read the DTCs following the prompts on the Techstream screen. Enter the following
menus: Powertrai ...
Terminals Of Ecu
TERMINALS OF ECU
CHECK ECM
HINT:
The standard voltage, resistance and waveform between each pair of the ECM terminals
is shown in the table below. The appropriate conditions for checking each pair of
the terminals is also indicated. The result of checks should be compared with the
standar ...
Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor RH deviates
more than the allowable range from the horizontal axis.
HINT:
If drum tester such as a speedometer tester, brake/speedometer combination tester
or chassis dynamometer is used with the blind spot monitor ...