Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Adjustment

ADJUSTMENT

CAUTION / NOTICE / HINT

HINT:

  • Centering bolts are used to mount the hood hinge and hood lock assembly. The hood and hood lock assembly cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
  • Specified torque for standard bolts is shown in the standard bolt chart (See page ). Text in Illustration

    *a

    Centering Bolt

    *b

    Standard Bolt

PROCEDURE

1. INSPECT HOOD SUB-ASSEMBLY

(a) Check that the clearance measurements of areas "A" though "D" are within each standard range.

Standard Clearance:

Standard Clearance:

Area

Measurement

Area

Measurement

A

-1.4 to 1.6 mm (-0.055 to 0.063 in.)

B

4.9 to 7.9 mm (0.193 to 0.311 in.)

C

4.9 to 7.9 mm (0.193 to 0.311 in.)

D

-1.4 to 1.6 mm (-0.055 to 0.063 in.)

2. ADJUST HOOD SUB-ASSEMBLY

(a) Horizontally and vertically adjust the hood.

(1) Loosen the 4 hinge bolts of the hood.

(2) Adjust the clearance between the hood and front fender by moving the hood.

(3) Tighten the 4 hinge bolts after adjustment.

Torque:

13 NВ·m {133 kgfВ·cm, 10 ftВ·lbf}

(b) Adjust the height of the front end of the hood using the hood bumper cushions.

(1) Adjust the 2 hood bumper cushions so that the heights of the hood and fenders are aligned.

(c) Adjust the hood lock assembly.

(1) Using a screwdriver with its tip wrapped in protective tape, remove the hood

(1) Using a screwdriver with its tip wrapped in protective tape, remove the hood lock nut cap.

Text in Illustration

*a

Protective Tape

(2) Loosen the 3 bolts.

(3) Adjust the hood lock assembly and tighten the 3 bolts.

Torque:

8.0 NВ·m {82 kgfВ·cm, 71 inВ·lbf}

(d) Install a new hood lock nut cap.

Hood
...

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals ...

Components
COMPONENTS ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 FORWARD RECOGNITION LATCH *3 NO. 1 FORWARD RECOGNITION COVER - - ...

Lost Communication with ECM / PCM "A" (U0100,U0125,U0126,U0129)
DESCRIPTION The millimeter wave radar sensor assembly and ECM communicate with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored. DTC No. Detection Item ...

2015-2021 © Copyright www.luting.site