COMPONENTS
ILLUSTRATION
*A |
w/ Off Road Package |
- |
- |
*1 |
NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
*2 |
NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY |
*3 |
FRONT UPPER FENDER APRON SEAL |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*A |
for Automatic Transmission |
- |
- |
*1 |
AUTOMATIC TRANSMISSION OIL COOLER TUBE |
*2 |
CLAMP |
*3 |
FAN AND GENERATOR V BELT |
*4 |
COOLER COMPRESSOR ASSEMBLY |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*1 |
POWER STEERING LINK |
*2 |
STEERING SLIDING YOKE |
*3 |
NO. 2 STEERING INTERMEDIATE SHAFT |
*4 |
PRESSURE FEED TUBE |
*5 |
RETURN HOSE |
*6 |
COTTER PIN |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
* |
For use with SST or a union nut wrench |
в—Џ |
Non-reusable part |
- |
- |
ILLUSTRATION
ILLUSTRATION
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Clutch Release Cylinder(for R156f)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DRAIN CLUTCH FLUID
2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
(See page )
3. DISCONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE
(a) Using a union nut wrench, disconnect the clutch release cylinder
to ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE REAR WHEEL
3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
(a) Remove the cap and valve core to release the air from the tire.
NOTICE:
Keep the removed cap and valve core.
(b) After ensuring that a sufficient amount of air has been rele ...