Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.

2. CHECK DLC3

(a) Check the DLC3 (See page 3. INSPECT BATTERY VOLTAGE ).

3. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 to 14 V

  • If the voltage is below 11 V, recharge or replace the battery.
Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Sliding Roo ...

Other materials:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The certification ECU (smart key ECU assembly) and ECM control the vehicle engine immobiliser system functions. Engine immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). In some cases, a ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Text in Illustration *1 Main Body ECU (Multiplex Network Body ECU) - - (a) Disconnect the driver side junction block and main body ECU (multiplex network body ECU) connect ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE CONNECTOR COVER (a) Disengage the 2 clips to remove the connector cover. 2. REMOVE REAR BUMPER PAD SUB-ASSEMBLY (a) Separate the 2 license plate light assemblies as shown in the illustration. ...

2015-2021 © Copyright www.luting.site