Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Engine

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the engine assembly, cylinder head sub-assembly, camshaft, No. 2 camshaft, No. 3 camshaft s ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT (See page ) 2. INSPECT ENGINE OIL (See page ) 3. INSPECT BATTERY (See page ) 4. INSPECT SPARK PLUG (See page ) 5. INSPECT AIR CL ...

Other materials:

Installation
INSTALLATION PROCEDURE 1. REMOVE MONOLITHIC CONVERTER PROTECTOR (a) Install the upper monolithic converter protector and lower monolithic converter protector with the 2 bolts and 2 nuts. Torque: 11 NВ·m {107 kgfВ·cm, 8 ftВ·lbf} (b) Install the clamp with the bolt as shown in the ...

Terminals Of Ecu
TERMINALS OF ECU 1. CLEARANCE WARNING ECU ASSEMBLY (a) Disconnect the C30 connector from the clearance warning ECU assembly. (b) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Descr ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE KNUCKLE GREASE RETAINER CAP (for 2WD) (a) Using a screwdriver and hammer, remove the knuckle grease retainer cap. 2. REMOVE FRONT AXLE HUB OIL SEAL (for 4WD) (a) Using a screwdriver and hammer, remove the front axle hub oil seal. 3. REMOVE FRONT WHEEL ADJUST ...

2015-2021 © Copyright www.luting.site