Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Engine Coolant Temperature Sensor

Toyota Tacoma 2015-2018 Service Manual / 2gr-fks Engine Control / Engine Coolant Temperature Sensor

Components

COMPONENTS

ILLUSTRATION

Inspection

Inspection

INSPECTION

PROCEDURE

1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR

(a) Partially immerse the engine coolant temperature sensor in water and warm up the water.

(b) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(Engine Coolant Temperature Sensor)

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Approx. 20В°C (68В°F)

2.32 to 2.59 kО©

Approx. 80В°C (176В°F)

0.310 to 0.326 kО©

NOTICE:

When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the sensor dry.

If the result is not as specified, replace the engine coolant temperature sensor.

Installation

INSTALLATION

PROCEDURE

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (See page (a) Apply a light coat of engine coolant to the O-ring of the engine coolant ).

(a) Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.

NOTICE:

  • When reusing the engine coolant temperature sensor, inspect the O-ring.
  • Make sure that the O-ring is not cracked or jammed when installing it on the rear water by-pass joint.
  • Replace with a new part if it is dropped or if it receives a strong impact.

(b) Install the engine coolant temperature sensor to the rear water by-pass joint with the clip.

(c) Connect the connector to the engine coolant temperature sensor.

2. INSTALL INTAKE MANIFOLD

(See page Removal Removal )

Removal

REMOVAL

PROCEDURE

1. REMOVE INTAKE MANIFOLD

(See page 2. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 2. REMOVE ENGINE COOLANT TEMPERATURE SENSOR )

2. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

(a) Disconnect the connector from the engine coolant temperature sensor.

(b) Remove the clip and engine coolant temperature sensor from the rear water by-pass joint.

Ecm
Components COMPONENTS ILLUSTRATION ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL NO. 2 ECM BRACKET (a) Install the No. 2 ECM bracket to the ECM with the 2 screws. Torque ...

2gr-fks Engine Mechanical
...

Other materials:

Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page ). HINT: Use the same procedure for both the RH and LH sides. The procedure describe ...

Customize Parameters
CUSTOMIZE PARAMETERS 1. CUSTOMIZING FUNCTION WITH TECHSTREAM NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make a note of the current settings before customizing. When troubleshooting a function, f ...

Steering wheel
The steering wheel can be adjusted to a comfortable position. Hold the steering wheel and press the lever down. Adjust to the ideal position by moving the steering wheel horizontally and vertically. After adjustment, pull the lever up to secure the steering wheel. CAUTION ■Caution whi ...

2015-2021 © Copyright www.luting.site