Toyota Tacoma 2015-2018 Service Manual: Engine Immobiliser
- Certification Ecu
- Engine Immobiliser System(w/ Smart Key System)
- Parts Location
- Precaution
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Registration
- Diagnosis System
- Dtc Check / Clear
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Engine Immobiliser System Incorrect Assembly (B279C95)
- Antenna Coil Open / Short (B2784)
- Engine Immobiliser System Signal (Some Circuit Quantity, Reported via Serial Data) Invalid (B279986)
- Malfunction of ID-BOX Recognition (B278D)
- Engine Immobiliser System Circuit Short to Battery (B279A12)
- Short to GND in Immobiliser System Power Source Circuit (B278A)
- Security Indicator Light Does not Blink
- Immobiliser System does not Operate Properly
- Engine Immobiliser System(w/o Smart Key System)
- Parts Location
- Precaution
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Registration
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Theft Deterrent System Communication Line High Fixation (B279A,B279A12)
- Theft Deterrent System Presence Detection (B279C,B279C95)
- Engine Immobiliser System Malfunction (B2799,B279986)
- Push Switch / Key Unlock Warning Switch Malfunction (B2780)
- Antenna Coil Open / Short (B2784)
- Transponder Chip Malfunction (B2793,B2794,B2797,B2798)
- Engine does not Start because No Initial Combustion
- Engine does not Start but Initial Combustion Occurs
- Key Cannot be Registered
- Security Indicator Light Does not Blink
- Transponder Key Amplifier
- Transponder Key Ecu
Tonneau Cover Assembly
Removal
REMOVAL
PROCEDURE
1. REMOVE TOP COVER SUB-ASSEMBLY
(a) Open the cover.
(b) Remove the bolt and top cover sub-assembly.
2. REMOVE RE ...
Certification Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Install the certification ECU (smart key ECU assembly) wit ...
Other materials:
Inspection
INSPECTION
PROCEDURE
1. INSPECT RADIATOR CORE SUB-ASSEMBLY
Check the core plate for damage.
Text in Illustration
*1
Core Plate
*2
Radiator Core
If the sides of the core plate groove are deformed, it is impossible
to reassem ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Check the DTCs.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Read the DTCs following the prompts on the Techstream screen. Enter the following
menus: Powertrai ...
Clearance Warning ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Clearance Warning ECU Communication Stop Mode
Either Condition is met:
Communication stop for "Clearance Warning (Intuitive Parking
Assist1)" is indicated on th ...