Use only floor mats designed specifically for vehicles of the same model and model year as your vehicle. Fix them securely in place onto the carpet.
Insert the retaining hooks (clips) into the floor mat eyelets.
Turn the upper knob of each retaining hook (clip) to secure the floor mats in place.
*: Always align the marks.
The shape of the retaining hooks (clips) may differ from that shown in the illustration.
Observe the following precautions.
Failure to do so may cause the driverвЂ™s floor mat to slip, possibly interfering with the pedals while driving. An unexpectedly high speed may result or it may become difficult to stop the vehicle, leading to a serious accident.
■When installing the driverвЂ™s floor mat
●Do not use floor mats designed for other models or different model year vehicles, even if they are Toyota Genuine floor mats.
●Only use floor mats designed for the driverвЂ™s seat.
●Always install the floor mat securely using the retaining hooks (clips) provided.
●Do not use two or more floor mats on top of each other.
●Do not place the floor mat bottom-side up or upside-down.
●Check that the floor mat is securely fixed in the correct place with all the provided retaining hooks (clips). Be especially careful to perform this check after cleaning the floor.
●With the engine stopped and the shift lever in P (automatic transmission) or N (manual transmission), fully depress each pedal to the floor to make sure it does not interfere with the floor mat.
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Dynamic Radar Cruise Control System DTC No. Detection Item MIL Link C1A02 Vehicle Information Not Obtained Does not come on C1A0A Front Radar Se ...
INSTALLATION PROCEDURE 1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (a) Remove SST from the extension housing. (b) Install the propeller shaft to the extension housing. (c) Completely remove any oil or the like and clean the contact surfaces of the propeller shaft flange and diff ...
Back-up Light Switch
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Pushed ...