Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Front Camera Module Incorrect Axial Gap (C1AA8)

Toyota Tacoma 2015-2018 Service Manual / Pre-collision / Pre-collision System / Front Camera Module Incorrect Axial Gap (C1AA8)

DESCRIPTION

If the millimeter wave radar sensor assembly detects that the beam axis of the forward recognition camera is misaligned, it will store DTC C1AA8.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AA8

Front Camera Module Incorrect Axial Gap

The millimeter wave radar sensor assembly continuously receives a signal indicating that the beam axis of the forward recognition camera is misaligned for 1 second or more.

Forward recognition camera system

PROCEDURE

1.

GO TO FORWARD RECOGNITION CAMERA SYSTEM

HINT:

If DTC C1AA8 is output by the pre-collision system, perform troubleshooting for the forward recognition camera system.

Click here

NEXT

END

Front Camera Module Circuit (C1AA0)
DESCRIPTION The millimeter wave radar sensor assembly receives information about the area in front of the vehicle from the forward recognition camera. If the millimeter wave radar sensor assembly ...

Front Camera Module Beam Axis Not Adjusted (C1AA9)
DESCRIPTION If forward recognition camera adjustment has not been performed or did not complete normally after the forward recognition camera was replaced with a new one, DTC C1AA9 will be stored ...

Other materials:

Turn Signal Switch Circuit
DESCRIPTION The combination meter assembly receives the turn signal switch information and controls the turn signal lights. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (TURN SIGNAL SWITCH) (a) Connect the Techstream to the DLC3. (b) Turn the igni ...

Operation Check
OPERATION CHECK 1. CHECK FUNCTION (a) Check that the key reminder warning buzzer sounds. (1) With the driver side door closed, insert the key into the ignition key cylinder and then turn the key to LOCK or ACC. (2) Check that the buzzer sounds intermittently when the driver side door is open ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Smart Key System) (a) Engage the 2 claws to install the un-lock warning switch assembly to the upper steering column bracket assembly. 2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Key System) (a) T ...

2015-2021 © Copyright www.luting.site