Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Front Radar Sensor Beam Axis Not Adjusted (C1A14)

Toyota Tacoma 2015-2018 Service Manual / Pre-collision / Pre-collision System / Front Radar Sensor Beam Axis Not Adjusted (C1A14)

DESCRIPTION

After installing a new millimeter wave radar sensor assembly, if sensor beam axis adjustment has not been performed, DTC C1A14 will be stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1A14

Front Radar Sensor Beam Axis Not Adjusted

When the vehicle is being driven at a speed of 10 km/h (7 mph) or more, incompletion of millimeter wave radar sensor assembly beam axis alignment is detected for approximately 1 second or more.

  • Millimeter wave radar sensor assembly adjustment has not been performed or has not been completed normally
  • Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
  • If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.

    Click here

PROCEDURE

1.

ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Perform millimeter wave radar sensor assembly adjustment.

Click here

NEXT

2.

CHECK FOR DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here (b) Make sure that the DTC detection conditions are met.

(b) Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

(c) Check for DTCs.

Click here

Result

Proceed to

DTC C1A14 is not output

A

DTC C1A14 is output

B

A

END (SENSOR BEAM AXIS ADJUSTMENT WAS NOT COMPLETED)

B

3.

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly.

Click here (b) Adjust the millimeter wave radar sensor assembly.

(b) Adjust the millimeter wave radar sensor assembly.

Click here

NEXT

4.

CLEAR DTC (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

NEXT

END

Front Radar Sensor Incorrect Axial Gap (C1A11)
DESCRIPTION When the vehicle is determined to be driving in a straight line or on a gradual curve based on signals from the yaw rate sensor, etc., the millimeter wave radar sensor assembly perfor ...

Yaw Rate Sensor (C1A46)
DESCRIPTION If the millimeter wave radar sensor assembly receives a yaw rate sensor malfunction signal from the yaw rate sensor (airbag sensor assembly) or yaw rate sensor zero point malfunction ...

Other materials:

Front Camera Module Circuit (C1AA0)
DESCRIPTION When an internal malfunction is detected in the forward recognition camera, DTC C1AA0 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C1AA0 Front Camera Module Circuit 3 seconds ...

Differential System(w/o Differential Lock)
Precaution PRECAUTION 1. Before disassembly, clean the outside of the front and rear differential assembly and remove any sand and mud to prevent it from entering the assembly during disassembly and installation. 2. When removing connected parts made of a light alloy, such as front and rear ...

Cooling System
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FOR COOLANT LEAK CAUTION: Do not remove the radiator cap sub-assembly, cylinder block drain cock plug or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and stea ...

2015-2021 © Copyright www.luting.site