Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Front Speed Sensor

Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 3. REMOVE FRONT WHEEL

3. REMOVE FRONT WHEEL

4. REMOVE FRONT SPEED SENSOR

(a) Disconnect the speed sensor connector.

(a) Disconnect the speed sensor connector.

(b) Remove the bolt and front speed sensor.

NOTICE:

  • Do not attach any foreign matter to the sensor tip.
  • Ensure that no foreign matter enters the sensor installation part.

Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT SPEED SENSOR

(a) Install the front speed sensor with the bolt.

Torque:

8.3 NВ·m {85 kgfВ·cm, 73 inВ·lbf}

NOTICE:

Make sure that the sensor tip is clean.

(b) Connect the speed sensor connector.

2. INSTALL FRONT WHEEL

Torque:

113 NВ·m {1152 kgfВ·cm, 83 ftВ·lbf}

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:

5.4 NВ·m {55 kgfВ·cm, 48 inВ·lbf}

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 4. CHECK VSC SENSOR SIGNAL (for Hydraulic Brake Booster)

4. CHECK VSC SENSOR SIGNAL (for Hydraulic Brake Booster)

Click here 5. CHECK VSC SENSOR SIGNAL (for Vacuum Brake Booster)

5. CHECK VSC SENSOR SIGNAL (for Vacuum Brake Booster)

Click here Multi-terrain Select Switch

Crawl Switch
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT CRAWL CONTROL SWITCH (DRIVE MONITOR SWITCH) (a) Check the resistance. (1) Measure the resistance according t ...

Multi-terrain Select Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE MULTI-TERRAIN SELECT SWITCH (DRIVE MONITOR SWITCH) (a) Disengage the 2 claws to remove the multi-terrain ...

Other materials:

4wd Control Ecu
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL 4 WHEEL DRIVE CONTROL ECU (a) Engage the 2 guides to install the 4 wheel drive control ECU. (b) Install the 2 bolts. Torque: 5.0 NВ·m {51 kgfВ·cm, 44 inВ·lbf} (c) Connect the 2 connectors. 2. INSTALL ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable f ...

Skid Control Buzzer Circuit (C1AA7)
DESCRIPTION The forward recognition camera operates the pre-collision warning by sending a buzzer request signal to the skid control buzzer. If the forward recognition camera detects a malfunction in the skid control buzzer circuit, it will output DTC C1AA7. DTC No. Dete ...

2015-2021 © Copyright www.luting.site