Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

  • Use these procedures to troubleshoot the combination meter.
  • *: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT

3.

CHECK CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Result

Proceed to

CAN communication DTC is not output

A

CAN communication DTC is output

B

B

GO TO CAN COMMUNICATION SYSTEM

A

4.

REFER TO PROBLEM SYMPTOMS TABLE

Result

Proceed to

Fault is not listed in Problem Symptoms Table

A

Fault is listed in Problem Symptoms Table

B

B

GO TO STEP 6

A

5.

CONDUCT OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List/Active Test

Click here

(b) Terminals of ECU

Click here

(c) On-vehicle Inspection

Click here

NEXT

6.

ADJUST, REPAIR OR REPLACE

NEXT

7.

CONDUCT CONFIRMATION TEST*

NEXT

END

Customize Parameters
CUSTOMIZE PARAMETERS 1. CUSTOMIZE METER / GAUGE SYSTEM (a) Customizing with the Techstream (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. ...

System Description
SYSTEM DESCRIPTION Text in Illustration *a Indication Example *b Tachometer *c Engine Coolant Temperature Receiver Gauge ...

Other materials:

Accessories, spare parts and modification of your Toyota
A wide variety of non-genuine spare parts and accessories for Toyota vehicles are currently available in the market. You should know that Toyota does not warrant these products and is not responsible for their performance, repair, or replacement, or for any damage they may cause to, or adverse ...

Camper information
This information has been prepared in accordance with regulation issued by the National Highway Traffic Safety Administration of the U.S. Department of Transportation. It provides the purchasers and/or prospective purchasers of Toyota vehicles with information on truck-camper loading. Your Toy ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONER PRESSURE SENSOR (for Automatic Air Conditioning System) (a) Check the wire harness. (1) Disconnect the A34 air conditioner pressure sensor connector. (2) Disconnect the A35 and A36 air conditioning amplifier assembly connector. ...

2015-2021 © Copyright www.luting.site