Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Inspection




(a) Flip the ball joint stud back and forth 5 times, as shown in the illustration,

(a) Flip the ball joint stud back and forth 5 times, as shown in the illustration, before installing the nut.

(b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.


1.0-3.0 NВ·m {3-45 kgfВ·cm, 3-39 inВ·lbf}

(c) Check for any cracks and grease leakage on the ball joint dust cover.

REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL 2. INSPECT FRONT SUSPENSION LOWER ARM (a) Install the hub nuts onto the disc. (b) Using a dial indicator, check the lower ball joint for excessive play w ...

INSTALLATION PROCEDURE 1. TEMPORARILY TIGHTEN FRONT SUSPENSION LOWER ARM (a) Align the matchmarks on the camber adjust cam No. 2 and toe adjust cam. Temporarily tighten the bolt and the nut. ( ...

Other materials:

Control Module Communication Bus OFF (U0073,U0100,U0124,U0126)
DESCRIPTION The skid control ECU (brake actuator assembly) receives the signals from the ECM, steering angle sensor (spiral cable with sensor sub-assembly), 4 wheel drive control ECU*, and yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. *: f ...

Pressure Control Solenoid "C" Actuator Stuck Off (P07957F)
SYSTEM DESCRIPTION The ECM uses the vehicle speed signal and signals from the transmission revolution sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of t ...

Hydraulic Test
HYDRAULIC TEST 1. PERFORM HYDRAULIC TEST (a) Measure the line pressure. CAUTION: The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels and wheel chocks while the other is performing the test. NOTICE: Perform ...

2015-2021 © Copyright