Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR BUMPER ASSEMBLY

(a) Using an engine lifter or equivalent, engage the 2 pins to install the rear bumper assembly.

Text in Illustration

*a

Pin

-

-

NOTICE:

  • Using plate lift attachments or equivalent, set the rear bumper assembly on a flat surface.
  • Be sure to perform the operation with 2 persons or more.
  • Be careful not to damage the rear bumper assembly.

(b) Install the 6 bolts.

Torque:

90 NВ·m {918 kgfВ·cm, 66 ftВ·lbf}

(c) Connect the 2 connectors.

2. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION (w/ Blind Spot Monitor)

Click here 3. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Blind Spot Monitor)

3. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Blind Spot Monitor)

Click here Reassembly

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR BUMPER HOLE COVER (a) Disengage the 2 clips to remove the rear bumper hole cover. 2. REMOVE REAR BUMPER PA ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER SIDE STAY LH (a) Install the rear bumper side stay LH with the 2 bolts. Torque: 30 NВ·m {306 kgfВ·cm, 22 ftВ·lbf} ...

Other materials:

Network Gateway Ecu
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL NETWORK GATEWAY ECU (a) Install the network gateway ECU with the bolt. Torque: 3.0 NВ·m {31 kgfВ·cm, 27 inВ·lbf} (b) Connect the connector. 2. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY (See page ) R ...

Black Screen
PROCEDURE 1. CHECK DISPLAY SETTING (a) Check that the display is not in "Screen Off" mode. OK: The display setting is not in "Screen Off" mode. NG CHANGE SCREEN TO SCREEN ON MODE OK ...

Propeller Shaft System
Problem Symptoms Table PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Che ...

2015-2021 © Copyright www.luting.site