Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page If the side airbag was deployed, replace the front seat assembly with ).
  • If the side airbag was deployed, replace the front seat assembly with a new one.

PROCEDURE

1. INSTALL FRONT SEAT ASSEMBLY

NOTICE:

  • Follow the procedure described below in order to prevent the seat tracks from locking separately.
  • Be careful not to damage the vehicle body.

(a) Place the front seat assembly in the cabin.

(b) Install the 2 bolts on the front side of the front seat assembly.

Torque:

37 NВ·m {377 kgfВ·cm, 27 ftВ·lbf}

(c) Install the 2 bolts on the rear side of the front seat assembly.

Torque:

37 NВ·m {377 kgfВ·cm, 27 ftВ·lbf}

(d) Connect the front seat airbag connector.

(e) Connect the connectors.

(f) Engage the wire harness clamp.

2. INSTALL SEAT TRACK COVER

HINT:

Use the same procedures for both sides.

(a) Engage the 2 claws to install the seat track cover.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:

5.4 NВ·m {55 kgfВ·cm, 48 inВ·lbf}

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 4. INSPECT SRS WARNING LIGHT

4. INSPECT SRS WARNING LIGHT

(See page Front Seat Assembly(for Front Passenger Side) )

Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing ...

Front Seat Assembly(for Front Passenger Side)
...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT BRAKE CYLINDER AND PISTON (a) Check the cylinder bore and piston for rust and scoring. 2. INSPECT PAD LINING THICKNESS (a) Using a ruler, measure the pad lining thickness. Standard thickness: 11.5 mm (0.453 in.) Minimum thickness: 1.0 mm (0.0394 in.) ...

Transponder Key Amplifier
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL TRANSPONDER KEY COIL (a) Engage the 2 claws to install the transponder key coil. (b) Connect the connector. 2. INSTALL UPPER STEERING COLUMN COVER (S ...

Removal
REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) Click here 2. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Manual Air Conditioning System) Click here 3. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 4. REMOVE INSTR ...

2015-2021 © Copyright www.luting.site