Toyota Tacoma 2015-2018 Service Manual: Installation

INSTALLATION

PROCEDURE

1. SET NO. 1 CYLINDER TO TDC/COMPRESSION

2. INSTALL CAMSHAFT TIMING GEAR BOLT

NOTICE:

There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque.

(a) Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.

(b) Temporarily install the camshaft timing gear bolt.

Torque:

10 NВ·m {102 kgfВ·cm, 7 ftВ·lbf}

HINT:

Make sure that the flange part of the camshaft timing gear bolt is directly contacting the camshaft timing gear assembly.

(c) Loosen the camshaft timing gear bolt 60 to 180В°.

(d) Turn the crankshaft pulley assembly counterclockwise approximately 30 to 90В°.

(e) Using SST, hold the crankshaft pulley assembly. SST: 09213-54015 91651-60855 SST: 09330-00021

(f) Tighten the camshaft timing gear bolt.

Torque:

for Type A :

120 NВ·m {1224 kgfВ·cm, 89 ftВ·lbf}

for Type B :

95 NВ·m {969 kgfВ·cm, 70 ftВ·lbf}

3. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

(See page )

4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Torque:

30 NВ·m {306 kgfВ·cm, 22 ftВ·lbf}

5. INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)

Torque:

30 NВ·m {306 kgfВ·cm, 22 ftВ·lbf}