Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR ENGINE OIL SEAL

(a) Apply MP grease to the lip of a new rear engine oil seal.

NOTICE:

Keep the lip free of foreign matter.

(b) Using SST, tap in a new rear engine oil seal until its surface is flush with the rear engine oil seal retainer edge.

SST: 09223-15030

SST: 09950-70010

09951-07100

NOTICE:

  • Keep the lip free of foreign matter.
  • Do not tap on the rear engine oil seal at an angle.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission) 3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission) 4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

6. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

6. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Transmission

See page

AC60E

AC60F

7. INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

(See page 2gr-fks Exhaust 2gr-fks Exhaust )

Removal
REMOVAL PROCEDURE 1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission) Transmission See page AC60E AC60F ...

2gr-fks Exhaust
...

Other materials:

Installation
INSTALLATION PROCEDURE 1. SET NO. 1 CYLINDER TO TDC/COMPRESSION 2. INSTALL CAMSHAFT TIMING GEAR BOLT NOTICE: There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque. *a Identification Ma ...

Main Switch Signal Circuit
DESCRIPTION When the wireless charger main switch (mobile wireless charger switch) is turned on, this circuit sends an on signal to the mobile wireless charger cradle assembly using the power supplied to the wireless charger main switch (mobile wireless charger switch). WIRING DIAGRAM CAU ...

Lost Communication with ECM (U0100,U0142,U0155)
DESCRIPTION DTC No. DTC Detecting Condition Trouble Area U0100 No communication with ECM CAN communication system ECM U0142 No communication with main body ECU ...

2015-2021 © Copyright www.luting.site