Toyota Tacoma 2015-2018 Service Manual: Lighting
- Automatic Light Control Sensor
- Cargo Light
- Cargo Light Switch
- Daytime Running Light Relay
- Deck Light Relay
- Fog Light Assembly(for Halogen Fog Light)
- Fog Light Assembly(for Led Fog Light)
- Fog Light Relay
- Front Door Courtesy Switch
- Hazard Warning Switch
- Headlight Assembly
- Headlight Dimmer Relay
- Headlight Dimmer Switch
- Headlight Relay
- High Beam Main Switch
- High Mounted Stop Light Assembly
- Interior Illumination Light
- License Plate Light Assembly
- Lighting System
- Precaution
- Parts Location
- System Description
- Customize Parameters
- How To Proceed With Troubleshooting
- Operation Check
- Dtc Check / Clear
- Problem Symptoms Table
- Terminals Of Ecu
- Light Sensor Circuit Malfunction (B1244)
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Automatic High Beam System (B124B)
- Automatic High Beam Camera (B124C)
- Lost Communication with Front Camera Module (U023A)
- Automatic High Beam System does not Operate or Operation Indicator does not Illuminate
- IG Signal Circuit
- Turn Signal Switch Circuit
- ACC Signal Circuit
- Daytime Running Light Relay Circuit
- Headlight Dimmer Switch Circuit
- Door Courtesy Switch Circuit
- Front Fog Light Circuit
- Hazard Warning Switch Circuit
- Interior Light Auto Cut Circuit
- Interior Light Circuit
- Engine Switch Illumination Circuit
- Taillight Relay Circuit
- Cargo Light Circuit
- Door Unlock Detection Switch Circuit
- High Beam Headlight Circuit
- Low Beam Headlight Circuit
- Personal Light Assembly
- Rear Combination Light Assembly
- Rear Door Courtesy Switch
- Room Light Assembly
- Side Turn Signal Light Assembly
- Stop Light Switch
- Towing Tail Relay
- Trailer Socket
- Vanity Light
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL INSTRUMENT PANEL CUSHION
(a) Install a new instrument panel cushion as shown in the illustration.
Text in Illustration
*a
...
Automatic Light Control Sensor
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
(a) Engage the 2 claws to install the automatic light control sensor.
2. ...
Other materials:
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY RH
(a) Connect the connector.
(b) Install the front No. 2 speaker assembly RH with the 2 bolts.
Torque:
8.4 NВ·m {86 kgfВ·cm, 74 inВ·lbf}
NOTICE:
Do not touch the cone part of the front No. 2 speaker assembly RH.
...
Combination Meter ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
Either condition is met:
Communication stop for "Combination Meter" is indicated on the
"Communication Bus Ch ...
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
Do not try to remove the black nylon tube as it is welded to the fuel suction
tube assembly (See page
).
PROCEDURE
1. REMOVE FUEL SENDER GAUGE ASSEMBLY
2. REMOVE NO. 1 FUEL SUB-TANK
(a) Disconnect the 2 fuel pump connectors.
...