Toyota Tacoma 2015-2018 Service Manual: Meter / Gauge / Display
- Combination Meter
- Meter / Gauge System
- Parts Location
- Precaution
- Customize Parameters
- How To Proceed With Troubleshooting
- System Description
- System Diagram
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Lost Communication with HMI-LAN (B150A)
- Diagnostic Trouble Code Chart
- On-vehicle Inspection
- Fuel Sender Open Detected (B1500)
- Open in Turn Signal Circuit (B1507,B1508)
- Lost Communication with ECM / PCM "A" (U0100,U0129,U0142,U0151,U0163,U023A,U1104)
- Entire Combination Meter does not Operate
- Speedometer Malfunction
- Tachometer Malfunction
- Engine Coolant Temperature Receiver Gauge Malfunction
- Fuel Receiver Gauge Malfunction
- Meter Illumination is Always Dark
- Meter Illumination does not Dim at Night
- Speed Signal Circuit
- Steering Pad Switch
Vanity Light
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedures for the LH and RH side.
The procedures listed below are for the LH sid ...
Combination Meter
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable fr ...
Other materials:
High Power Supply Voltage Malfunction (C1417)
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU
(housed in the master cylinder solenoid) stores this DTC and the fail-safe function
prohibits ABS/VSC/TRAC operation.
This DTC is stored when the IG1 terminal voltage deviates from the DTC detection
co ...
Operation Check
OPERATION CHECK
1. BLIND SPOT MONITOR BEAM AXIS INSPECTION
(a) Procedure to enter Test Mode
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the blind spot monitor main switch assembly (warning canceling switch
assembly) on.
(4) Turn the Techstream on.
(5 ...
Clutch Switch Circuit
DESCRIPTION
While depressing the clutch pedal, the clutch start switch assembly sends a signal
to terminal MTN of the 4 wheel drive control ECU. While the signal is input, switching
between H4 and L4 is possible.
WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING TECHSTREA ...