Toyota Tacoma 2015-2018 Service Manual: Multiplex Communication
- Lin Communication System
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Terminals Of Ecu
- Data List / Active Test
- Diagnosis System
- Dtc Check / Clear
- Communication Malfunction between ECUs Connected by LIN (B2785)
- No Response from Steering Lock ECU (B2786)
- Diagnostic Trouble Code Chart
- Sliding Roof ECU Communication Stop (B1273)
- Driver Side Door ECU Communication Stop (B2321)
- LIN Communication Bus Malfunction (B2325)
- P/W Master Switch Communication Stop (B1206)
- Lost Communication with Power Source Control (B278C)
- Front Passenger Side Door ECU Communication Stop (B2322)
Network Gateway Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL NETWORK GATEWAY ECU
(a) Install the network gateway ECU with the bolt.
Torque:
3.0 NВ·m {31 kgfВ·cm, 2 ...
Other materials:
Brake Switch "B" Circuit Short to Battery (P070312)
DESCRIPTION
The purpose of this circuit is to prevent the engine from stalling while driving
in lock-up when the brakes are suddenly applied.
When the brake pedal is depressed, this switch sends a signal to the ECM. Then
the ECM cancels the operation of the lock-up clutch while braking is in p ...
Removal
REMOVAL
PROCEDURE
1. REMOVE ENGINE ASSEMBLY
(See page )
2. REMOVE IGNITION COIL ASSEMBLY
3. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
4. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank
1)
5. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exha ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC (CHECK USING TECHSTREAM)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble
Codes.
(e) Check for DTCs, and then write them down.
( ...