Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Operation Check

OPERATION CHECK

1. CHECK WIRELESS CHARGING SYSTEM OPERATION

(a) Turn the ignition switch ON (IG or ACC).

(b) Press the mobile wireless charger switch and check that the switch indicator light illuminates.

Text in Illustration

*a

Switch Indicator Light

(c) Place a rechargeable device on the charging area and check that the indicator light (amber) illuminates, indicating a charge is in progress.

Text in Illustration

*a

Indicator Light (Green)

*b

Indicator Light (Amber)

*c

Charging Area

(d) Check that the indicator lights (amber and green) are illuminated when charging is complete.

HINT:

  • Some phones, cases or cover type wireless chargers may not cause the green indicator to illuminate even though it is fully charged.
  • Check the mobile device to confirm charge status.

HINT:

Please refer to precaution for the details (See page Problem Symptoms Table ).

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the wireless charging system. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials:

Parking Brake Switch Circuit
DESCRIPTION This circuit is from the parking brake switch assembly to the navigation receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK VEHICLE SIGNAL (OPERATION CHECK) (a) Display the "Vehicle Signal Check Mode" screen (See page ). ...

Detecting Vehicle Submersion (B2277)
DESCRIPTION This DTC is stored when a malfunction in the water submersion detection circuit in the certification ECU (smart key ECU assembly) is detected. HINT: When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it w ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for 2GR-FKS) 2. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY (a) Remove the 2 bolts and propeller shaft heat insulator bracket. 3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (a) Place matchmarks on the propeller sh ...

2015-2021 © Copyright www.luting.site