Toyota Tacoma 2015-2018 Service Manual: Rc62f Manual Transmission / Transaxle
- Back-up Light Switch
- Counter Gear
- Input Shaft
- Manual Transmission Assembly
- Manual Transmission Oil
- Manual Transmission System
- Precaution
- Parts Location
- System Diagram
- Check For Intermittent Problems
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecm
- Check Mode Procedure
- Data List / Active Test
- Dtc Check / Clear
- Diagnostic Trouble Code Chart
- Lost Communication With ECM/PCM "A" Missing Message (U010087)
- Crankshaft Position Sensor "A" Signal Stuck in Range (P03352A,P033531)
- Vehicle Speed Sensor "A" No Signal (P050031)
- Manual Transmission Unit
- Neutral Position Switch
- Output Shaft
Propeller Shaft System
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symp ...
Back-up Light Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table be ...
Other materials:
Clearance Warning ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the clearance warning ECU assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuse for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
1.
CHECK HARNES ...
Television Camera
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR TELEVISION CAMERA ASSEMBLY
(a) Install the rear television camera assembly with the 2 bolts.
Torque:
5.5 NВ·m {56 kgfВ·cm, 49 inВ·lbf}
(b) Connect the connector.
2. INSTALL TAIL GATE SERVICE HOLE ...
System Diagram
SYSTEM DIAGRAM
Transmitting ECU (Transmitter)
Receiving ECU
Signal
Communication Method
Skid control ECU (Brake actuator assembly)
Steering angle sensor (Spiral cable with sensor sub-assembly)
Steering angl ...