Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Rear Power Outlet Switch

Components

COMPONENTS

ILLUSTRATION

Inspection

Inspection

INSPECTION

PROCEDURE

1. INSPECT MAIN SWITCH ASSEMBLY

(a) Check the main switch assembly.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(Main Switch Assembly)

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

6 (IG) - 3 (E)

Switch on

Below 1 О©

Switch off

10 kО© or higher

  • If the specified condition is not met, replace the main switch assembly.

(b) Check the switch indicator.

(1) Apply battery voltage to the main switch assembly and check that the switch indicator illuminates.

OK:

Measurement Condition

Switch Condition

Specified Condition

Battery positive (+) в†’ 5 (IND+)

Battery positive (-) в†’ 2 (IND-)

Always

Illuminates

OK:

Measurement Condition

Switch Condition

Specified Condition

Battery positive (+) в†’ 6 (IG)

Battery positive (-) в†’ 4 (IND)

Always

Illuminates

  • If the specified condition is not met, replace the main switch assembly.

Removal

REMOVAL

PROCEDURE

1. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH

(See page ) ) )

2. REMOVE MAIN SWITCH ASSEMBLY

(a) Disengage the 2 claws to remove the main switch assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL MAIN SWITCH ASSEMBLY

(a) Engage the 2 claws to install the main switch assembly.

2. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH

(See page ) ) )

Rear Power Outlet Socket
Components COMPONENTS ILLUSTRATION ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL POWER OUTLET SOCKET ASSEMBLY (a) Install the clamp. (b) Connect the connector. ...

Voltage Inverter
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT VOLTAGE INVERTER ASSEMBLY (a) Check the voltage inverter assembly. (1) Measure the voltage according to the ...

Other materials:

Transmission Fluid Temperature Sensor "B" Circuit Low Input (P2742,P2743)
DESCRIPTION The No. 2 ATF temperature sensor is installed in the transmission valve body assembly. If the ECM detects an abnormally high ATF temperature near this sensor, it illuminates the warning indicator. HINT: The temperature of ATF easily rises when towing, climbing hills, in ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DRIVER SEAT BELT WARNING LIGHT HINT: The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat. (a) Turn the ignition switch to ON. (b) When the driver seat belt is not fastened, check th ...

Chassis
General Maintenance GENERAL MAINTENANCE PROCEDURE 1. INSPECT STEERING LINKAGE (a) Check the steering wheel free play (See page ). (b) Check the steering linkage for looseness or damage. (1) Check that the tie rod ends do not have excessive play. (2) Check that the dust seals and boots are ...

2015-2021 © Copyright www.luting.site