Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

(See page ) ) )

2. REMOVE NO. 3 HEATER TO REGISTER DUCT

3. REMOVE INSTRUMENT PANEL WIRE ASSEMBLY

3. REMOVE INSTRUMENT PANEL WIRE ASSEMBLY

(a) Using a screwdriver with its tip wrapped in protective tape, release the 3 airbag connector locks.

Text in Illustration

*a

Protective Tape

(b) Disconnect the 3 airbag connectors.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.

(c) Disengage the 2 clamps to remove the instrument panel wire assembly.

4. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY WITHOUT DOOR

(a) Remove the 2 screws.

(b) Disengage the 3 hooks (A).

Text in Illustration

*a

Hooks (A)

*b

Hooks (B)

(c) Disengage the 3 hooks (B) to remove the instrument panel passenger airbag assembly without door from the instrument panel.

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY WITHOUT DOOR (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check (See pa ...

Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre ...

Other materials:

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: If one of the camshaft timing gear bolts is already removed, do not remove any other camshaft timing gear bolts. PROCEDURE 1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package) 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3. REMOVE ...

Parts Location
PARTS LOCATION ILLUSTRATION *A for Automatic Transmission *B for Manual Transmission *C for 4WD - - *1 FRONT SPEED SENSOR LH *2 FRONT SPEED SENSOR RH ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Smart Key System) (a) Engage the 2 claws to install the un-lock warning switch assembly to the upper steering column bracket assembly. 2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Key System) (a) T ...

2015-2021 © Copyright www.luting.site