Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page NOTICE: ).

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 3. REMOVE FRONT SEAT ASSEMBLY RH

3. REMOVE FRONT SEAT ASSEMBLY RH

Click here 4. REMOVE OCCUPANT DETECTION ECU

4. REMOVE OCCUPANT DETECTION ECU

(a) Disconnect the 2 connectors from the occupant detection ECU.

(a) Disconnect the 2 connectors from the occupant detection ECU.

(b) Disengage the claw to remove the occupant detection ECU.

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT OCCUPANT DETECTION ECU (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check (See page ). 2. INSPECT OCCUPANT DETECTION ECU (fo ...

Installation
INSTALLATION PROCEDURE 1. INSTALL OCCUPANT DETECTION ECU (a) Check that the ignition switch is OFF. (b) Check that the cable is disconnected from the battery negative (-) terminal is disconnecte ...

Other materials:

Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3) (P0796)
SYSTEM DESCRIPTION The ECM uses the vehicle speed signal and signals from the transmission revolution sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of t ...

Compass (vehicles with auto anti-glare inside rear view mirror)
The compass on the inside rear view mirror indicates the direction in which the vehicle is heading. ■ Operation Type A To turn the compass on or off, press the button. Type B ■ Displays and directions Calibrating the compass The direction display deviates from the true ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR WHEEL 2. DRAIN BRAKE FLUID HINT: Immediately wash off any brake fluid that comes into contact with any painted surfaces. 3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (a) Release the parking brake, and remove the rear brake drum. If the rear brake drum cannot be ...

2015-2021 © Copyright www.luting.site