Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the RH and LH side.
  • The procedure described below is for the LH side.

PROCEDURE

1. REMOVE REAR ACCESS PANEL WEATHERSTRIP

2. REMOVE LAP BELT OUTER ANCHOR COVER

2. REMOVE LAP BELT OUTER ANCHOR COVER

3. REMOVE ACCESS PANEL INSIDE HANDLE BEZEL

3. REMOVE ACCESS PANEL INSIDE HANDLE BEZEL

4. REMOVE DOOR PULL HANDLE

4. REMOVE DOOR PULL HANDLE

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

6. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

6. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

NOTICE:

The rear door glass sub-assembly may fall while performing this procedure. Therefore, use suction cups to hold the rear door glass sub-assembly from the outside of the vehicle.

(a) Apply protective tape to the area around the installation position of the rear door glass sub-assembly on the vehicle body to prevent it from being scratched.

Text in Illustration

*a

Protective Tape

*b

Piano Wire

(b) Install the suction cups to the quarter window assembly.

(c) Pass a piano wire between the vehicle body and rear door glass sub-assembly from the interior.

(d) Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

(e) Cut off the adhesive by pulling the piano wire around the rear door glass sub-assembly.

(f) Using suction cups, disengage the 3 clips to remove the rear door glass sub-assembly.

Components
COMPONENTS ILLUSTRATION ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DOOR GLASS SUB-ASSEMBLY (a) Clean and shape the contact surface of the vehicle body. Text in Illustration *a ...

Other materials:

Center Airbag Sensor Assembly
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check (See page ). 2. INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision a ...

Adjustment
ADJUSTMENT PROCEDURE 1. ADJUST PARK/NEUTRAL POSITION SWITCH (a) While pushing the shift lock release button, move the shift lever to N. (b) Remove the bolt of the park/neutral position switch. (c) Clean the bolt and bolt hole. (d) Apply adhesive to 2 or 3 threads on the end of the bolt. Adhes ...

Components
COMPONENTS ILLUSTRATION *1 CHARCOAL CANISTER ASSEMBLY *2 CHARCOAL CANISTER FUEL HOSE *3 CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY *4 FUEL TANK VENT HOSE *5 FUEL TANK ...

2015-2021 © Copyright www.luting.site