Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Transmission

See page

AC60E

AC60F

2. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

(See page 3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission) 3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission) )

3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

5. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

5. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission) 6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

7. REMOVE REAR ENGINE OIL SEAL 7. REMOVE REAR ENGINE OIL SEAL

7. REMOVE REAR ENGINE OIL SEAL

(a) Using a knife, cut off the lip of the rear engine oil seal.

Text in Illustration

*a

Cut Position

(b) Using a screwdriver, pry out the rear engine oil seal.

NOTICE:

Do not damage the surface of the rear engine oil seal press fit hole or crankshaft.

HINT:

Tape the screwdriver tip before use.

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new rear engine oil seal. NOTICE: Keep the lip free of foreign matter. (b) Using SST, tap in ...

Other materials:

Lock Switch Circuit
WIRING DIAGRAM PROCEDURE 1. CHECK REAR DIFFERENTIAL LOCK INDICATOR LIGHT (a) Turn the ignition switch to ON. (b) for 4WD: Finish switching to L4. (c) Check the rear differential lock indicator light. (d) Press the differential lock switch. (e) After 60 secon ...

Installation
INSTALLATION PROCEDURE 1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY (with Grease Fitting) HINT: When replacing the spider bearing, make sure that the grease fitting assembly hole is facing in the direction shown in the illustration. Text in Illustration *1 No. 1 Grease Fi ...

Components
COMPONENTS ILLUSTRATION *A for Driver Side - - *1 FRONT SEAT CUSHION HEATER ASSEMBLY *2 SEPARATE TYPE FRONT SEAT CUSHION COVER *3 TAG PIN - - ...

2015-2021 © Copyright www.luting.site