Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: System Description

SYSTEM DESCRIPTION

1. FRONT PASSENGER OCCUPANT CLASSIFICATION SYSTEM

(a) General Description

(1) The front passenger occupant detection ECU determines whether the front passenger seat is occupied by an adult or child (with child seat) or is unoccupied, based on the load that is applied to the front passenger seat and whether the seat belt is buckled. The system restricts the deployment of the front passenger airbag, front passenger side airbag, and the front passenger seat belt pretensioner in accordance with this judgment. The result is informed to the driver through the airbag ON/OFF indicator illumination.

(b) System Configuration

(1) This system consists of the occupant detection ECU, occupant classification sensors, airbag ON/OFF indicator, seat belt buckle switches, and airbag sensor assembly.

(c) Occupant Detection ECU and Sensor

(1) The occupant classification sensors are installed on four brackets connecting the seat rail and the seat frame. The resistance values of these sensors, which vary in accordance with the load that acts on the brackets, are transmitted to the occupant detection ECU as signals. Upon receipt of the signals, the ECU determines the front passenger seat occupant conditions.

System Diagram
Initialization
INITIALIZATION 1. ZERO POINT CALIBRATION NOTICE: Make sure that the front passenger seat is not occupied before performing the operation. HINT: Perform the zero point calibration and sensitivit ...

System Diagram
SYSTEM DIAGRAM ...

Other materials:

Sliding Roof ECU Communication Stop (B1273)
DESCRIPTION This DTC is stored when LIN communication between the sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (multiplex network body ECU) stops for 10 seconds or more. DTC No. DTC Detection Condition Trouble Area ...

Precaution
PRECAUTION 1. PRECAUTIONS WHEN USING TECHSTREAM (a) When using the Techstream with the engine switch off to troubleshoot: Connect the Techstream to the DLC3, and turn a courtesy light switch on and off at 1.5 second or less intervals until communication between the Techstream and vehicle begin ...

Check Bus 3 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and ...

2015-2021 © Copyright www.luting.site