Toyota Tacoma 2015-2018 Service Manual: Tire And Wheel
- Tire And Wheel System
- Tire Pressure Warning Receiver
- Tire Pressure Warning System
- Parts Location
- Precaution
- System Diagram
- System Description
- Initialization
- Registration
- Problem Symptoms Table
- Terminals Of Ecu
- Test Mode Procedure
- Data List / Active Test
- Dtc Check / Clear
- Transmitter ID not Received in Main Mode (C2126/26)
- Transmitter ID1 Error (C2141/41-C2144/44)
- Diagnostic Trouble Code Chart
- Transmitter ID not Registered (C2171/71)
- Receiver Error (C2176/76)
- Lost Communication with Brake System Control Module (U0129/29)
- Initialization not Completed (C2177/77)
- Tire Pressure Monitor ECU Communication Stop (C2179/79)
- Initialization Switch (for Test Mode DTC) (C2198/98)
- Tire Pressure Monitor Receiver Communication Stop (B1247)
- Transmitter ID1 Operation Stop (C2111/11-C2114/14)
- No Signal from Transmitter ID1 (C2121/21-C2124/24,C2181/81-C2184/84)
- ECU Power Source Circuit
- TC and CG Terminal Circuit
- Tire Pressure Warning Light Circuit
- Tire Position Not Identified
- Tire Pressure Warning Valve And Transmitter
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
...
Other materials:
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT FENDER SEAL LH
(a) Remove the 5 clips and front fender seal LH.
2. REMOVE FRONT FENDER SEAL RH
HINT:
Use the same procedure as for the LH side.
3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Disengag ...
Compressor Lock Sensor Circuit (B1422/22)
SYSTEM DESCRIPTION
The ECM sends the engine speed signal to the air conditioning amplifier assembly
via CAN communication.
The air conditioning amplifier assembly reads the difference between compressor
speed and engine speed. When the difference becomes too large, the air conditioning
ampli ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY
(a) Connect the actuator hose and connector.
(b) Install the No. 1 mounting support with the 3 bolts.
Torque:
186 NВ·m {1899 kgfВ·cm, 138 ftВ·lbf}
(c) Install the No. 2 mounting support with the 2 bolts.
Torque:
160 N ...