Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: TS and CG Terminal Circuit

DESCRIPTION

In Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (See page PROCEDURE PROCEDURE ).

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMBLY - TS of DLC3)

(a) Turn the ignition switch off.

(b) Disconnect the S1 skid control ECU (brake actuator assembly) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

S1-24 (TS) - D4-12 (TS)

Always

Below 1 О©

S1-24 (TS) or D4-12 (TS) - Body ground

Always

10 kО© or higher

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

D4-4 (CG) - Body ground

Always

Below 1 О©

Text in Illustration

*a

Front view of DLC3

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

VSC Buzzer Circuit
DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication. The combination meter has a built-in VSC warning buzzer: Sounds inte ...

VSC OFF Switch Circuit
DESCRIPTION The skid control ECU assembly is connected to the combination meter assembly via CAN communication. Pressing the VSC OFF switch turns off TRAC operation, and pressing and holding thi ...

Other materials:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION The main body ECU (multiplex network body ECU) and certification ECU (smart key ECU assembly) control the LIN communication system. LIN communication system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3). When th ...

System Description
SYSTEM DESCRIPTION 1. WIRELESS DOOR LOCK CONTROL SYSTEM The wireless door lock control system functions to lock and unlock all the doors from a distance. The system is controlled by a door control transmitter module set sub-assembly which sends radio waves to the door control receiver. The mai ...

Parts Location
PARTS LOCATION ILLUSTRATION *1 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) *2 THROTTLE BODY WITH MOTOR ASSEMBLY *3 PARK/NEUTRAL POSITION SWITCH *4 VSC OFF SWITCH *5 MILLIMETER ...

2015-2021 © Copyright www.luting.site