Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Vacuum Warning Switch

Components

COMPONENTS

ILLUSTRATION

On-vehicle Inspection

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

2. INSPECT BRAKE BOOSTER ASSEMBLY

3. INSPECT VACUUM WARNING SWITCH ASSEMBLY

3. INSPECT VACUUM WARNING SWITCH ASSEMBLY

(a) Start the engine and stop it after 1 or 2 minutes.

(b) Disconnect the connector from the vacuum warning switch assembly.

(c) Measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

10 kО© or higher

(d) With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

Below 1 О©

(e) Connect the connector to the vacuum warning switch assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL VACUUM WARNING SWITCH GROMMET

(a) Install a new vacuum warning switch grommet to the brake booster assembly.

2. INSTALL VACUUM WARNING SWITCH ASSEMBLY

(a) Install the vacuum warning switch assembly to the brake booster assembly as shown in the illustration.

Text in Illustration

Center of the Brake Booster Assembly

(b) Connect the connector to the vacuum warning switch assembly.

Removal

REMOVAL

PROCEDURE

1. REMOVE VACUUM WARNING SWITCH ASSEMBLY

(a) Disconnect the connector from the vacuum warning switch assembly.

(b) Remove the vacuum warning switch assembly from the brake booster assembly.

2. REMOVE VACUUM WARNING SWITCH GROMMET

(a) Remove the vacuum warning switch grommet from the brake booster assembly.

Vacuum Pump
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL VACUUM PUMP ASSEMBLY (a) Apply engine oil to the 2 O-rings on the vacuum pump assembly. (b) Apply engine ...

Brake Control / Dynamic Control Systems
...

Other materials:

Side Turn Signal Light Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY (See page ) 2. REMOVE OUTER ...

USB Device Malfunction (B1585)
DESCRIPTION This DTC is stored when a malfunction occurs in a connected device. DTC No. DTC Detection Condition Trouble Area B1585 USB Device Malfunction Non mass-storage class or incompatible protocol USB device ...

System Description
SYSTEM DESCRIPTION 1. SYSTEM DESCRIPTION (a) The Electronic Controlled Automatic Transmission (ECT) is an automatic transmission that has its shift timing electronically controlled by the ECM. The ECM detects electrical signals that indicate engine and driving conditions, and controls the sh ...

2015-2021 © Copyright www.luting.site