Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: VSC OFF Indicator Light does not Come ON

DESCRIPTION

Refer to VSC OFF Indicator Light Remains ON (See page WIRING DIAGRAM ).

WIRING DIAGRAM

Refer to VSC OFF Indicator Light Remains ON (See page CAUTION / NOTICE / HINT ).

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the skid control ECU (master cylinder solenoid), perform calibration (See page ). Inspect the fuses for circuits related to this system before performing ).
  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.

CHECK CAN COMMUNICATION SYSTEM

NG

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

OK

2.

INSPECT SKID CONTROL ECU (CSW TERMINAL)

NG

GO TO STEP 4

OK

3.

READ VALUE USING TECHSTREAM (TRAC/VSC OFF MODE)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.

ABS/VSC/TRAC

Tester Display

Measurement Item

Control Range

Diagnostic Note

TRAC/VSC Off Mode

TRAC/VSC off mode/ Normal, TRC OFF, Unknown or VSC OFF

Normal: Normal mode

TRC OFF: TRAC OFF mode

VSC OFF: VSC OFF mode

-

(f) Check that the mode display changes according to VSC OFF switch operation.

OK:

Display changes according to switch operation.

OK

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

NG

REPLACE MASTER CYLINDER SOLENOID

4.

INSPECT VSC OFF SWITCH

NG

REPLACE VSC OFF SWITCH

OK

5.

INSPECT ROOF CONSOLE BOX ASSEMBLY (MASTER CYLINDER SOLENOID - VSC OFF SWITCH)

A

REPAIR OR REPLACE HARNESS OR CONNECTOR (MASTER CYLINDER SOLENOID - ROOF CONSOLE BOX ASSEMBLY)

B

REPLACE ROOF CONSOLE BOX ASSEMBLY

C

REPLACE ROOF CONSOLE BOX ASSEMBLY

Slip Indicator Light Remains ON
DESCRIPTION The slip indicator light blinks during VSC or TRAC and AUTO LSD operation. When the system fails, the slip indicator light comes on to warn the driver. WIRING DIAGRAM CAUTION / NOTI ...

AUTO LSD Indicator Light does not Come ON
DESCRIPTION The AUTO LSD does not operate even if the VSC OFF switch is pressed under the following conditions: The brake system is faulty. The temperature inside the hydraulic brake bo ...

Other materials:

Installation
INSTALLATION PROCEDURE 1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY WITHOUT DOOR (a) Engage the 3 hooks (B). Text in Illustration *a Hooks (A) *b Hooks (B) ...

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: If one of the camshaft timing gear bolts is already removed, do not remove any other camshaft timing gear bolts. PROCEDURE 1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package) 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3. REMOVE ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY (a) Insert the 5 hooks, install 6 new bolts, 2 new clips with pins and 2 new ...

2015-2021 © Copyright www.luting.site